Nanoleaf app fails to reconnect

Started by Psycrow
E581bfe9cc048a06ea1e07bc81e24bbd?s=128&d=mm

Psycrow

I have the 9 nanoleaf aurora plates installed and i connected em to the app on the mobile. If i reboot my router or turns the power off/on the the app fails to reconnect. I can only controlle the lights on my brower with this site login and the controller it self. Then i need to reset the controller and seach for device and enter pair and wifi codes again.

Sometimes it even messes up and says " oops error" when i enter the pair code again.
Or even in worst case i need to reinstall the app and hard reset the lights.

So has anyone else tryed to turn ther router off and on again to see if the app fails to connect ?

Im using the latest app drivers firmware an dthe lights works fine.
Its ONLY when i reebot my router " power off/on" then it messes with me..

E581bfe9cc048a06ea1e07bc81e24bbd?s=128&d=mm

Psycrow

After i did a reset of the controller and reinstalled the app, then it says "Unassigned device" under rooms. And everytime i download a new scene then i must press the device i want to download it for..maybe its broken ?